GeoChip Instructions

1: Loosen the stem clamp.

2: Remove the stem top cap.

3: Remove stem, handlebars, stem spacers, headset top cap and bearing, and slide the fork out of the headtube.

4: Pull the top GeoChip from the headtube. It should be removable by hand.

5: Ensure the GeoChip seat in the headtube is greased, flip the GeoChip around to the desired position, and press it back into the headtube by hand.

6: Repeat the same for the bottom chip.

7: If using an Angle Adjust GeoChip, ensure the upper chip's indicated size matches your frame size.

Angle adjustment is designated by the side of the chip which point fowards.

Note: the orientation of the top and bottom chips must match for correct beaing alignment.

8: Slide the fork steerer back through the headtube, ensuring the bottom bearing is installed

9: Reinstall the upper headset bearing, split ring, top cap, stem spacers, stem, and stem top cap

Note: if you changed to a different GeoChip than the one originally installed, you may need to adjust the stem spacers to ensure proper preload on the headset bearing.

10: Torque the stem to the manufacturer's specifications

You're done, ride on!